Search

4S 40A Li-ion Lithium Battery 18650 Charger PCB BMS Protection Board For 14.8V 16.8V Lipo Cell Module

Products > Battery Protection Board > 4S 40A Li-ion Lithium Battery 18650 Charger PCB BMS Protection Board For 14.8V 16.8V Lipo Cell Module
    • 1
    • 2
    • 3

4S 40A Li-ion Lithium Battery 18650 Charger PCB BMS Protection Board For 14.8V 16.8V Lipo Cell Module

4 string 16.8V 40A lithium battery protection board (comes with recovery function-AUTO Recovery)

Scope: Nominal voltage of 3.6V, 3.7V lithium battery (including 18650,26650, polymer lithium battery)

Product Size: 45 * 55 * 3.4mm (Standard Edition / Enhanced), 46 * 60 * 3.4mm (balanced version)

Product weight: 9.3g (standard / enhanced version), 10.3g (balanced version)

Charging voltage: 16.8V - 18.1V


shared：



4 string 16.8V 40A lithium battery protection board (comes with recovery function-AUTO Recovery)
 
Scope: Nominal voltage of 3.6V, 3.7V lithium battery (including 18650,26650, polymer lithium battery)
 
Product Size: 45 * 55 * 3.4mm (Standard Edition / Enhanced), 46 * 60 * 3.4mm (balanced version)
 
Product weight: 9.3g (standard / enhanced version), 10.3g (balanced version)
 
Charging voltage: 16.8V - 18.1V
 
Continuous discharge current (upper limit): 40A (if the cooling environment is not good, please reduce the load current use)
 
Continuous charge current (upper limit): 20A
 
Equalization version: suitable for starting current below 80A, power 135W below the drill.



Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit

TTP223 TTP223B Jog digital touch sensor capacitive touch touch switch modules Accessories

The module is a capacitive touch switch module based on touch detection IC (ttp223b). Under normal condition,the module outputs low level and the mode is low power consumption mode; when touching the corresponding position with fingers, the module outputs high level and the mode switches to fast mode; when there is no touch for 12 seconds, the mode switches to low power consumption mode.

Electric Unit PAM8610 12V 2x15W Dual Channel Stereo C Digital power amplifier board

This plate with switching function, SW short, will turn off the power amplifier Working Mode: Class D (PWM modulation type) Chip Type: PAM8610 Power Range: DC 6V-15V (self-protection) Recommended Voltage: DC 12V(2A) Output Power: 10Wx2(8Ω) 15Wx2(4Ω) Frequency Response: 20HZ-15KHZ Static Current: 20MA (DC12V) SNR: 90% Recommended Speakers: 10-100W Input Impedance: 15K Output Impedance: 4-8Ω Harmonic Distortion: <0.1% Size: Approx. 3cm x 2.5cm/ 1.19" x 0.98"

GY-530 VL53L0X Laser Ranging Sensor ToF Ranging Time of Flight Ranging Sensor Module

DIY kit 3 Channel 2 * 18W 30W High Power Fever Super Bass AC TDA2030A Dual 12V Power Amplifier Board 2.1

4S 30A High Current Li-ion Lithium Battery 18650 Charger Protection Board 14.4V 14.8V 16.8V BMS

1. Module name: 4 series lithium battery protection board 2. Modular nature: polymer lithium battery protection board 3. Overcharge detection voltage: 4.25 ± 0.025V 4. Overcharge release voltage: 4.15 ± 0.05V 5. Overdischarge detection voltage: 2.50 ± 0.08V 6. Over-discharge termination voltage: 3 ± 0.1V 7. Overcurrent: 20-30A

HC-SR501 Adjust IR Pyroelectric Infrared PIR Motion Sensor Detector Module

Automatic induction: When someone enters its induction range, enter the high level, people leave the sensor range is automatically delayed off high. Output low. 2. photosensitive control (optional): the module reserved for location, can be set to photosensitive control, strong light during the day or not induction. Photosensitive control is optional, the factory did not install photosensitive resistor. If necessary, please buy a separate photosensitive resistor to install.

CC1101 Intelligent Industrial Wireless RF Communication Module SPI Transceiver Module 868MHz

Features: 1.Low power UHF wireless transceivers @ 868MHZ 2.Support FSK , GFSK , ASK / OOK and MSK 3.Configurable data rate 1.2K to 500kps 4.Two 64 bytes FIFO for TX & RX buffer 5.Packet handling including address recognition 6.Support Wake-on-radio 7.Support Clear Channel Assessment（Listen-before-talk ) 8.RSSI Output &Link Quality Indictor 9.SPI Interface 10.Wide Operating Voltage 1.8-3.6V

IRS2092S 500W Mono Channel Digital Amplifier Class D HIFI Power Amp Board 20Hz-20KHz Digital Amplifier Module

GSM module, SIM808 Module with GPS antenna GSM GPRS GPS development board

This module is 5-12V power supply, when the power supply is less than 9V, 2A DC is required. The other power supply port is 3.5-4.2V, suitable for lithium battery power supply. The computer can debug USB-TTL. Suitable for portable. Two sets of antenna SMA ports, GPS and GSM antennas are provided.

PAM8403 Wireless Stereo Audio Receiver Module For Digital Amplifier Sound Loud Board Micro USB BlUETOOTH 4.0 3W+3W

1. Working voltage: DC 5V 2. Output power: 3W+3W 3. Speaker type: 3W*2 4-8ohm 4. Mounting Hole: 3.0mm Features: Mini design, sound loud and clear, strong sense of hierarchy, ultra-small size, simple installation, wide application range, low prices, quality and stability

74HC595 driver 8-digit digital tube display module

1. Two 595 digital tubes are used to drive the digital tube, which needs 3 IO ports of single chip microcomputer, and it is displayed according to the principle of dynamic scanning of digital tube; 2. wide working voltage 3.3V to 5V; 3. PCB size: 71mm * 22mm 4. digital tube model: 0.364 bits

16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685 DIY Servo Shield Module

DC DC Boost Converter Constant Module Current Mobile Power Supply 250W 10A LED Driver Module Non-isolated Step Up Module

Applications: 1, DIY a power supply, 12V can input and output can 12-50V adjustable. 2, the power supply for your electronic device, according to your system can set the output voltage value. 3, as the car power supply for your laptop, PDA or a variety of digital products supply. 4, DIY a mobile notebook power supply: 12V coupled with high-capacity lithium battery pack, so you can go where light where books. 5, solar panel regulator.

Mini Ble Audio Receiver Amplifier Board Module With Stereo Speakers

L298N motor driver board module intelligent vehicle robot accessory H-bridge drive stepper motor driver
Previous： XL4016 DC/CC Adjustable 0.2- 9A 300w Step Down Buck Converter 5-40V To 1.2-35V Power Supply Module LED Driver
Next： DC5V-12V Charging module for lithium battery 18650 UPS voltage converter uninterruptible power supply module
Return
TOP
86-755-83877216
smartbes
smartbes