Search

SIM900A module, development board, GSM/GPRS/STM32 \ super TC35i wireless data transmission module

Products > Modules > SIM900A module, development board, GSM/GPRS/STM32 \ super TC35i wireless data transmission module
    • 1
    • 2
    • 3
    • 4

SIM900A module, development board, GSM/GPRS/STM32 \ super TC35i wireless data transmission module

Product Description:

ardu 51 STM32 AVR MCU compatible
Prototype expand
The dual frequency 900/ 1800 MHz, GPRS multi-slot class 10/8,GPRS mobile station class B
Power supply range: voltage is 4.6-5.2v; current is 1A or more(the current is very important).
Low power consume: 1.5mA (sleep mode)
Operating temperature range: -40 degrees C to +85 C
Communication interface: The TTL level serial interface compatible 2.85 3.3 5v MCU
Size:49*50mm
shared：


Product Description: 

ardu 51 STM32 AVR MCU compatible
Prototype expand
The dual frequency 900/ 1800 MHz, GPRS multi-slot class 10/8,GPRS mobile station class B
 Power supply range: voltage is 4.6-5.2v; current is 1A or more(the current is very important).
 Low power consume: 1.5mA (sleep mode)
 Operating temperature range: -40 degrees C to +85 C
 Communication interface: The TTL level serial interface compatible 2.85 3.3 5v MCU
Size:49*50mm




Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit

RS422 to TTL/UART/MCU Serial Port Signal Mutual Module with Over-Voltage Over-Current Protection-3.3V

VCC: + 3.3V TXD : The module's TTL (UART) to send, connected to the microcontroller's RXD receiver pin; RXD : The module's TTL (UART) receiver, connected to the microcontroller TXD send pin; GND : The module ground wire (this wire must be connected with the ground wire of microcontroller system);

500W Mono Channel Digital Amplifier Class D HIFI Power Amp Board 20Hz-20KHz Digital Amplifier Module

Use precautions: 1. Rated supply voltage is ±65V, ±58---±70V range, do not over 70V! positive and ​negative do not pick wrong 2. Recommended power supply ±65V 3. Recommended 4-8Ω / 10-18inch speaker 4. Carefully check before electricity, ensure the wiring is correct.

XH-M542 Mono Digital Power Amplifier Board TPA3116D2 High Power Amplifier 100W

Product parameters: Supply voltage: DC12-26V Output power: 100W Signal to noise ratio: 100db Number of channels: mono Product size: 79*54*16(mm)

HC-SR501 Adjust IR Pyroelectric Infrared PIR Motion Sensor Detector Module

Automatic induction: When someone enters its induction range, enter the high level, people leave the sensor range is automatically delayed off high. Output low. 2. photosensitive control (optional): the module reserved for location, can be set to photosensitive control, strong light during the day or not induction. Photosensitive control is optional, the factory did not install photosensitive resistor. If necessary, please buy a separate photosensitive resistor to install.

MAX31865 temperature sensor detector module temperature acquisition RTD/PT100-PT1000

●Support 100Ω to 1kΩ (at 0°C) platinum resistance RTD (PT100 to PT1000) ●Conversion time: 21ms (maximum) ●15-bit ADC resolution; nominal temperature resolution is 0.03125°C (non-linear change with RTD) ● Under the whole working conditions, the total accuracy is maintained at 0.5°C (0.05% full range) ● SPI compatible interface, compatible with 2-wire, 3-wire and 4-wire sensor connection

Wedding special igniter 12V DC universal high voltage generator pulse high voltage module output 60KV arc

BLE 4.0 serial port patch type cc2540 cc2541 data transparent transmission iBeacon module

☆Ultra-low standby power consumption 90uA~400uA ☆ Ultra-long connection distance 100 feet/60 meters ☆Super fast response speed 0.4 seconds ☆ Android, Apple, PC, MAC are all universal. ☆No byte limit for sending and receiving, up to 3K Bytes/sec ☆ No need to do MFI ☆ IOS system is perfectly supported. ☆Android 4.3 system is perfectly supported.

ACS712ELC-05B 5A range ACS712 module AC current sensor module

1. Current sensor chip: ACS712ELC-05B; 2. Pin 5V power supply, onboard power indicator; 3. The module can measure plus or minus 5A current, corresponding to the analog output 185mV/A; 4. When no detection current passes, the output voltage is VCC/2; 5. PCB board size: 31(mm)x13(mm);

Original UNO R3 development board original single-chip C language programming learning motherboard kit

MH-Z19B CO2 detection sensor module Infrared carbon dioxide sensor

MH-Z19B 0-5000PPM Mh-z19c 400-5000ppm C is an upgrade of B Carbon dioxide gold shell (non mh-z19) 400-5000ppm Carbon dioxide white shell (non mh-z19) 400-5000ppm

PAM8403 Mini 5V Digital Small Power Amplifier Board (USB supply)

Product Name: pam8403 digital power amplifier board Specification and model: gf1002 Power supply range: 5V DC Minimum output: 3W * 2 Appearance size: 29.5 * 20.2 * 15mm (excluding protruding potentiometer rod)

High power three channel amplifier module TDA2050+TDA2030 2.1 subwoofer amplifier circuit board

HW-658 GSM/GPRS Mould USB GPS Module For Raspberry Pi

Suitable For Raspberry Pi A B A+ B+ Zero 2 3. Connect via 1*8 2.54 separation distance pin header or USB micro data cable. Adopting L80-39 mould project, with 15 x 15 x 4mm Patch aerial. Super low power consumption, quick location. Support Short-circuit Protection and Aerial Detection. Support self-auxiliary AGPS (EASY technology), no need of external memory. Support LOCUS, DGPS, SBAS(WAAS/EGNOS/MSAS/GAGAN).

QC2.0 QC3.0 Quick Charging USB Mobile Phone Charging Board DC Step-down Module
Previous： XL 6009 DC to DC Step Up Converter xl6009 step-up power module dc motor
Next： Wedding special igniter 12V DC universal high voltage generator pulse high voltage module output 60KV arc
Return
TOP
86-755-83877216
smartbes
smartbes