Search

HC-05 master-slave integrated BlE module DIY wireless serial port transparent electronic module BLE

Products > Modules > HC-05 master-slave integrated BlE module DIY wireless serial port transparent electronic module BLE
    • 1
    • 2
    • 3
    • 4
    • 5

HC-05 master-slave integrated BlE module DIY wireless serial port transparent electronic module BLE

shared：
Product model
HC05
Air speed
2Mbps
Working frequency band
2.4G
Antenna interface
built-in PcB antenna
Communication cable
15mA
Working voltage
3.0-3.6V
Receiving sensitivity
-85dBm@2Mbps
RSSI support
not supported
Transmission power
4dbm
Working temperature
-25 ℃ -75 ℃
Working humidity
10% -90%
Communication level
3.3v
Reference distance
10 meters
Storage temperature
-40 ℃ -80 ℃
Product Description


Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit

1.2V 12V ZB2L3 18650 Li-ion Lithium Battery Capacity Resistance Lead-acid Meter Discharge Tester

Maximum support 15V 3A discharged through the discharge voltage and current, itself does not discharge Maximum capacity statistics support 9999Ah (9999000mAh) Automatically identify and develop appropriate battery termination voltage can also be manually adjusted

High power three channel amplifier module TDA2050+TDA2030 2.1 subwoofer amplifier circuit board

AC-DC Power Supply Module AC 100-240V to DC 24V 9A Switching Power Supply Board

AC-DC Power Supply Module AC 100-240V to DC 24V 9A Switching Power Supply Board Product Description: Input voltage: AC 100-240V 50/60HZ Output Voltage: DC 24V Output Current: 6-9A Output Power: 150W ( Max 220W ) Location Pore Size: 105.8 x 55.7mm Overall Dimensions: 115 x 65mm Ripple Noise: Less than 150MV Overcurrent protection: Yes Overload Protection: Yes Short circuit protection: Yes

New Arrival Raspberry Pi 3 Model B+ Wide Angle Camera 5MP Adjustable-focus Mini Vision Video Camera module

Temperature (Operation): -20°C to 70°C Temperature (Stable Image) : 0°C to 50°C Focus :Fixed Object distance:30CM-∞ Resolution: 800LW/PH (Center) Working power supply : 3.3v(pin15) Operating system: for Raspberry Pi Certifications :FCC and CE Sensor Type: OV5647 (1/4” ) Active Array Size : 2592*1944 Sensitivity: 600mV/Lux-sec F/No: 2.35 EFL: 1.55 mm BFL(Optical): 3.1mm FOV: 160° TV Distortion :<14.5% Relative Illumination (Sensor) : 70% IR Filter : 650±10nm

High-Precision Low-ower INMP441 Omnidirectional Microphone Module I2S Interface Supports ESP32

For ARM PIC AVR DSP 10A 5V 2 Channel Relay Module Shield

Specifications : Size: 3.9cm x 5.1cm Materials: PCB board and electronic components Package included : 1 x 5V 2-Channel Relay Module Shield

100W 2SC5200+2SA1943 Audio Amplifier Board Mono Channel HIFI Power Amplifier Board Dual DC35V

Operating voltage: Dual DC 10 - 45V recommended Dual DC 35V Rated output power :100W(4 Ohm ± 35V) Maximum output power : 150W (4 Ohm ± 45V) enormous heat, is not recommended PCB size :30 x 50 x 35mm Pitch : 5.08mm Hole distance between two power tube : 47mm

New version ESP-12E (replace ESP-12) ESP8266 remote serial Port WIFI wireless module ESP8266-12E ESP12E

ESP8266-12E Is an enhanced version ESP8266-12 , improve the external circuit, enhanced impedance signal output is better, whether it is stable or anti-jamming capability , have been greatly improved ! Before selecting a user for ESP-12 's , it does not matter even if the product has been made , enhanced version is fully compatible with previous firmware pin has added the ESP-12 on the basis of six IO ports , SPI mouth leads , develop more convenient, application more extensive !

L298N motor driver board module intelligent vehicle robot accessory H-bridge drive stepper motor driver

XL 6009 DC to DC Step Up Converter xl6009 step-up power module dc motor

This DC-DC Module is based on IC XL6009E1 which is a high-performance step-up switching current (BOOST) module. The module uses the second generation of high-frequency switching technology XL6009E1 core chip that offers superior performance over the first generation technology LM2577. XL6009 replaces LM2577 module as LM2577 is about to be phased out.

TTGO T-Display ESP32 WiFi And Ble Module Development Board

Chipset： ESPRESSIF-ESP32 240MHz Xtensa® single-/dual-core 32-bit LX6 microprocessor FLASH： QSPI flash 4MB SRAM： 520 kB SRAM Button： Reset USB to TTL： CP2104 Modular interface： UART,SPI,SDIO,I2C,LED PWM,TV PWM,I2S,IRGPIO,ADC,capacitor touch sensor,DACLNA pre-amplifier

Dual coil fast wireless charger transmitter module PCBA board + 2 coil general qi standard diy board

Product Parameters 1. Input power supply: 5V 2A or 9V 1.67-2a, output: 5V 1A or 9V 1.2A 2. Product weight: 0.035kg 3. Charging power: 5W / 7.5w/10w automatic identification 4. Transmission distance: 2-8mm 5. Executive standard: Qi wireless charging standard 6. Product certification: CE / FCC / RoHS

MAX485 Module RS-485 TTL to RS485 MAX485CSA Converter Module

1 on-board MAX485 chip , is a tool for RS-485 communications , low-power , Slew-Rate Transceiver 2 onboard then 5.08 (mm) pitch 2P terminal for easy wiring RS-485 communication 3 the chip has drawn all of the pins can be controlled by the microcontroller operation 4 Working voltage : 5V 5 board size : 44 (mm) x14 (mm)

16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685 DIY Servo Shield Module

STM32F103C8T6 ARM STM32 Minimum System Development Board Module

CH32F103C8T6 chip is compatible with STM32F103C8T6 series chips, all pins are compatible, all registers are compatible.
Previous： TP4056 18650 lithium battery module 3.7V 3.6V 4.2V lithium battery charging board 1A overvoltage protection
Next： 16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685 DIY Servo Shield Module
Return
TOP
86-755-83877216
smartbes
smartbes